Siemens TS45450 - Manual (Page 21)

21
SIEMENS
EN
gl
ISH
H
Storing the
appliance
1. Always allow the appliance to cool down before
storing it.
2. Set the main power button to the “0” position (the
red light will go off) and disconnect the mains
cable.
3. Empty the water tank.
4. Place the iron on the iron pad (2), standing on the
soleplate, and fix it by inserting the tip of the iron
into the front slot and moving the fixation system
lever (10) against the heel of the iron.
5. Store the mains cable (5) and steam hose (6) in
the storage compartment (4). Do not wrap the
cords too tight.
6. Hold the iron´s handle when moving the
appliance, as shown in figure H, or use the
carrying handles (3) on the sides.
Disposal
Our goods come in optimised packaging. This
basically consists in using non-contaminating
materials which should be handed over to the local
waste disposal service as secondary raw materials.
Your local town council can give you information
about how to dispose of obsolete appliances.
This appliance is labelled in
accordance with European Directive
2012/19/EU –concerning used
electrical and electronic appliances
(waste electrical and electronic
equipment WEEE).
The guideline determines the
framework for the return and recycling of used
appliances as applicable throughout the EU.
g
rinsing the iron steam
chamber
E E
Caution! risk of burns!
This procedure helps to remove scale particles from
the steam chamber.
This cleaning procedure may be performed
occasionally (approximately once a year), when after
a long period of use with very hard water, scale
particles start to come out of the soleplate.
a) Ensure that the iron has cooled down.
b) Fill the tank with tap water.
c) Plug in the mains cable and set the main power
button (9) to the “I” position, (illuminated in red).
d) Set the temperature to the setting.
e) Set the steam setting to and wait until the icon
stops flashing.
f) Hold the iron over the sink or a container to
collect the water.
g) Press the steam release button (13) and gently
shake the iron. Boiling water and steam will be
released, carrying scale and or deposits that
might be inside. This could take approximately 5
minutes.
h) Set the temperature to the setting, without
pressing the steam release buttons (13-14*).
The water in the steam chamber will start
evaporating. Wait until all the water inside the
chamber has been evaporated.
i) To clean the soleplate, immediately rub off any
residue by running the hot iron over dry cotton cloth.
Cleaning &
maintenance
E E
Caution! risk of burns!
always unplug the appliance from the mains
supply before carrying out any cleaning or
maintenance operation on it.
1. After ironing, disconnect the plug and allow the
appliance to cool down before cleaning.
2. Wipe the housing, handle and iron body with a
damp cotton cloth.
3. If the soleplate is soiled with dirt or scale, clean it
with a damp cotton cloth.
4. Never use abrasive products or solvents.