Siemens TE501501DE - Manual (Page 37)

33
en
Service programme
Duration: approx� 35 minutes
Depending on use, the service button (12)
flashes at certain intervals.
The appliance should be cleaned and
descaled immediately using the service
programme. If the service programme is
not run as instructed, the appliance may
be damaged�
A Caution!
Follow the instructions for using the
descaling and cleaning agents for each
service programme� Please observe the
safety instructions on the packaging of the
cleaning agent�
Never interrupt the service programme�
Do not drink the liquids�
Never use vinegar, vinegar­based products,
citric acid or citric acid­based products.
Never put descaling tablets or other
descaling agents in the drawer (4)�
Specially developed and suitable
descaling and cleaning tablets are
available from retailers or customer
service (see “Accessories”).
Important: If there is a water filter in the
water tank (16), it must be removed before
starting the service programme� Clean the
brewing unit before starting the service
programme, see chapter “Cleaning the
brewing unit”.
To start the service programme, press and
hold the service button (12) for at least
5 seconds�
Information: The service button (12)
flashes while the programme is running.
LED
H
lights up�
● Empty the drip tray (8) and reinsert it.
The appliance rinses twice�
LED
G
lights up�
● Open the drawer (4)�
● Drop a Siemens cleaning tablet into
the drawer (4) and close it�
● Press the start button (10)�
LED
D
lights up�
● Pour lukewarm water into the empty
water tank (16) up to the 0.5 l mark
and then dissolve 1 Siemens descaling
tablet TZ80002 in it� When using
TZ60002, 2 tablets must be dissolved�
● Press the start button (10)�
The service programme will now run for
approximately 10 minutes.
LED
F
lights up�
● Place a container with a capacity of at
least 0�5 litres under the milk frother
outlet (6)�
● Pull out the milk frother (6) to open it�
The service programme will now run for
approximately 12 minutes.
LED
D
lights up�
● Rinse the water tank (16) and refill it
with fresh water up to the max mark�
● Press the start button (10)�
The service programme will now run for
approximately 30 seconds and rinse the
appliance�
LED
F
lights up�
● Push the milk frother (6) in to close it�
The service programme will now run for
approximately 8 minutes.
LED
H
lights up�
● Empty the drip tray (8) and reinsert it.
If you are using a filter, reinsert it now.