Matrix Orbital GLK19264A-7T-1U - Manual (Page 44)

Command Summary 39
11.7 Auto
Repeat Mode
Off Dec
Hex
ASCII 254 96
FE 60
■ `
v8.0
Turns auto repeat mode off. Default is on (typematic).
11.8 Assign
Keypad Codes Dec
Hex
ASCII 254 213
FE D5
■ ╒
Key Down Key Up
Key Down Key Up
Key Down Key Up v8.0
Assigns the key down and key up values sent to the host when a key press is detected. A key up and key down
value must be sent for every key, a value of 255 will leave the key unaltered. Defaults are shown below.
Key Down Bytes [9] Key down values.
Key Up Bytes [9] Key up values.
Figure 20: Default Tactile Key Down Values Figure 21: Default Tactile Key Up Values
*Note: Values are not mapped to a physical key.
11.9 Keypad
Backlight Off Dec
Hex
ASCII 254 155
FE 9B
■ ¢
v8.4
Turns the keypad backlight off.
11.10 Set Keypad
Brightness Dec
Hex
ASCII 254 156
FE 9C
■ £
Brightness
Brightness
Brightness v8.4
Immediately sets the keypad brightness. On time is set using the Backlight On command. Default is 255.
Brightness Byte Brightness level from 0(Dim) to 255(Bright).