Wagner 915 On-Demand Steamer - Manual (Page 7)

7 English
When you
are finished
steaming
Storage:
When you have completed your steaming job, follow
the steps below to store the unit.
1. Shut the unit OFF (O).
2. Activate trigger untill all pressure has been released.
3. Unplug power cord.
4. Allow steamer to cool for at least twenty (20)
minutes.
5. Activate trigger to release pressure. Remove all
accessories from handle.
6. Empty any remaining water in reservoir to prevent
overfilling the next time the steamer is used. NeVeR
store the unit with water in the container.
7. Place the unit in a cool, dry location.
impORTaNT: always store the unit empty.
impORTaNT: NeVeR store the unit temperatures
below 40º F (4º C).
Maintenance:
Over time, the reservoir may experience mineral
build-up caused by the high mineral content found
in most local water supplies. One way to avoid this
is to use distilled water with this steamer. if you are
unable to use distilled water, follow the steps below
to remove mineral build-up. It is recommended that
these steps be performed on a periodic basis.
1. Follow steps 1-6 in Storage, left.
2. Using a measuring cup, mix 8 ounces of vinegar and
8 ounces of water.
3. Slowly pour water/vinegar mixture into the reservoir.
4. Allow the unit to sit for at least thirty (30) minutes.
5. Empty the reservoir of the water/vinegar mixture.
6. Rinse reservoir with fresh water and drain. Repeat
until vinegar odor dissipates.
7. Replace fill cap and store unit in a cool, dry place.