beautypg.com

Usage, Before you begin, Lo o – Wagner 915 On-Demand Steamer User Manual

Page 5

background image

5

English

Usage

Start

Using the trigger

Wallpaper removal

Cooling / refilling

1. For best results, use a scoring tool or a

putty knife and gently score the wallpaper

in a crisscross pattern before removal. The

perforations will allow the steam to penetrate

the wallpaper.

2. To remove wallpaper, hold the steam plate flat against the

scored wallpaper. Pull the trigger and hold for 15-20 seconds.

Move the steam plate to a new section and remove the

steamed section with a scraper blade.

Note: Just turning the power OFF does not relieve

steam pressure. During cool down, treat the unit as if

it is under pressure. Always activate the trigger before

removing the fill cap.

1. You can control the flow of steam from the

accessory by activating the trigger.

The trigger will also relieve any built-up

pressure remaining in the system after the

steamer has been shut off.

DO NOT leave steam plate

unattended, or face down on any

surfaces.
DO NOT operate the steamer once

the water container is empty. make

sure to wear gloves and eye

protection.
Before unscrewing the filler cap

and filling the reservoir, make sure

any remaining water has cooled for

at least twenty (20) minutes. Empty

any remaining water to avoid

over-filling.
Do not look directly down into the

fill hole when filling. Keep your

free hand and others at a safe

distance.
The spray handle may become

warm to the touch during usage.

Note: Before using, trigger the spray handle

into a sink or empty bucket to purge any

remaining cold water.

Before you begin:

1. Shut the unit OFF.

Activate trigger until all pressure

has been released.

2. Unplug power cord.

Allow steamer to cool for at least

twenty (20) minutes.

* See NOTE, above.

3. Once unit has sufficiently cooled,

repeat steps 4-6 in setup to

continue.

2

15-20 SEC.

1

1

l

O

O

1

2

3

Off

20 minuteS