Wagner ProCoat Max - Manual (Page 5)

English 5
Proper
use and
functions
Start
Controls and Functions
ON/OFF switch:
The ON/OFF switch turns power
to sprayer on and off.
(O=OFF, |=ON)
PRIME/SPRAY knob:
The PRIME/SPRAY knob directs
material to the material return
tube when set to PRIME or to
spray hose when set to SPRAY.
Spray hose:
The spray hose connects the
spray gun to the pump.
Pressure control:
The pressure control function is
also controlled by the PRIME/
SPRAY knob. The pressure
control regulates the amount
of force the pump uses to push
the fluid and can be adjusted for
desired spray pattern.
Spray gun:
The spray gun controls the
delivery of the material being
pumped.
Trigger lock:
Engage the trigger lock whenever
the gun is not in use.
The gun is locked when the
trigger lock is at a 90º angle
(perpendicular to the trigger in
either direction).
Material return tube (a):
Fluid is sent out through the
return tube and back into the
original container when the
PRIME/SPRAY knob is in the
PRIME position.
Suction tube (b):
The suction tube draws the fluid
from the original container into
the pump.
Sprays a variety of paints (oil-based and
latex), primers, stains, preservatives and other
nonabrasive materials. Do not use materials
with flash points below 70° F (21° C)
Do not use!
This pump should not be used with textured
materials, block filler, lacquers, industrial
enamels, or asphalt sealer or materials
containing HHC. See coating supplier if flash
point is not listed on the container
Safety features:
Spray gun trigger lock and pressure diffuser;
built-in tip safety guard; PRIME/SPRAY knob
for safe pressure release. Conforms to ULSTD
1450. Certified to CAN/CSAC 22.2 NO 68-92
Specifications
Weight ................................28.5 lbs
Flow rate .............................0.24 gal/minute
Power source......................1/2 Hp universal
motor
Power requirement .............15 amp minimum
circuit on 120 VAC,
60 Hz current
Generator requirement .......5000 Watt
Max. spraying pressure ......2800 PSI
Capability:
(a)
(b)
CLEAN ROLL CLEAN ROLL
MAX MAX
SPRAY - MINIMuM
PRESSuRE
Ideal for thinner spray
materials.
Also to be used
during cleanup, when
unclogging the tip, or
when using the optional
roller attachment.
SPRAY - MAxIMuM
PRESSuRE
Ideal when spraying
thicker materials.
To be used during
spraying.