Assembly, English – Wagner Flexio 890 Sprayer User Manual

Page 7

English

Assembly

Before you begin:

nEVER point the spray nozzle at

any part of the body.

IMPORTanT: Make sure the power cord is unplugged.

To Assemble:

1. Insert the suction tube into the intake opening.
2. align the suction tube -

a. If you are going to be spraying in a downward

direction, the angled end of the suction tube should

be pointing toward the front of the nozzle.

b. If you are going to be spraying in an upward direction,

the angled end of the suction tube should be pointing

toward the rear of the nozzle.

note: Make sure the suction tube is inserted as far as it will

go to ensure a tight fit.

3. Carefully screw the cup back onto the nozzle assembly.

Tighten firmly.

4. Align the arrow on the nozzle with the “unlock” symbol

on the spray gun handle.

5. Insert and twist the nozzle into the handle toward the

“lock” symbol on the handle. The tab below the trigger

will lock the two pieces into place.

6. Insert the air hose tightly into the air hose port in the

Power Box.

IMPORTanT: If the unit has already been used, make

sure the nozzle seal is in place (see pages 13-14).

7. Turn the Power Box switch ON (I). Turn switch on handle

to ON (I). The turbine will not run until handle switch is

set to ON (l).

note : Do not pull trigger at any time if the turbine is not

running.