Wagner Control Spray - Manual (Page 7)

7 English
Maintenance
2. Remove the dirty
filters and replace
with new ones. The
smooth side of the air
filter must be placed
toward the turbine.
3. Secure the cover back onto the turbine.
Never operate your unit without the air filters. Dirt could
be sucked in and interfere with the function of the unit.
1. Unplug the spray
gun. Remove the
filter cover from the
turbine by removing
the two screws
holding it in place.
You should inspect the air filter in the turbine to see if it
is excessively dirty. If it is dirty, follow the steps below
to replace it.
Troubleshooting
Problem
A. Little or no material flow
B. Material leaking
C. Atomization is too coarse
D. Spray jet pulsates
E. Pattern runs or sags
F. Too much overspray
G. Pattern is very light and
splotchy.
Cause
1. Nozzle clogged.
2. Suction tube clogged.
3. Material volume setting turned too low (-).
4. Suction tube loose.
5. No pressure build up in container.
6. Air filter clogged.
1. Nozzle loose.
2. Nozzle worn.
3. Nozzle seal worn.
4. Material build-up on air cap and nozzle
1. Viscosity of material too high.
2. Material volume too large.
3. Material volume setting too high (+).
4. Nozzle clogged.
5. Air filter clogged.
6. Too little pressure build-up in container.
1. Material in container running out.
2. Air filter clogged.
1. Applying too much material.
1. Gun too far from spray object.
2. Too much material applied.
1. Moving the spray gun too fast.
Solution
1. Clean.
2. Clean.
3. Increase volume setting (+).
4. Insert.
5. Tighten container.
6. Change.
1. Tighten.
2. Replace.
3. Replace.
4. Clean.
1. Thin.
2. Decrease volume setting (-).
3. Decrease volume setting (-).
4. Clean.
5. Change.
6. Tighten container.
1. Refill.
2. Change.
1. Adjust material flow or increase
movement of spray gun.
1. Reduce distance.
2. Decrease volume setting (-).
1. Adjust material flow or decrease
movement of spray gun.
Have you tried the recommendations above and are still having problems? In the United States, to speak to a
customer service representative, call our Customer Service at 1-800-328-8251 Monday through Friday between 8:00
AM and 4:30 PM Central time. An automated Self-Help option is also available at 1-800-328-8251, seven days a week,
twenty-four hours a day.
Product Registration Card
Send in your product registration card or register online at www.wagnerspraytech.com. Proper registration will serve as proof of
purchase in the event your original receipt becomes misplaced or lost. Returning this card will expedite the processing of your warranty.
Be sure you write your unit’s
date code on the card before sending it. The date code is located underneath the base of your unit
(for example, S087R). The additional information will also help us to develop new products that best meet your needs and desires.