Wagner SMART Flow Roller - Manual (Page 3)

3 English
1. Filling the
main tube
Start Before filling:
Your Smart Flow Roller can be used with two
types of container lids that are used to allow
you to pull material from the material container
into the Smart Flow Roller.
The lid below is desiged for use with standard,
one-gallon, round material containers. This lid
comes standard with your Smart Flow Roller.
Use the lid shown below if you are using
something other than a standard, one-gallon,
round material container. *not included with
all models.
Attaching the container lid / fill tube
Filling the main tube
1. Apply a thin layer of
petroleum jelly to the fill
tube. This will help the fill
valve slide easily off the fill
tube.
1. Slide the small end of the fill tube
(a) through the hole in the container
lid you plan to use.
2. Press down and firmly hold the fill
valve onto the fill tube.
3. Make sure lever is switched to POWER (b).
Push the lower part of the switch (c) to draw
the plunger out and fill the tube. When the
tube is full, you are ready to begin rolling.
2a. Standard containers - Attach the
container lid with fill tube securely
to the material container.
2b. all other containers - Thread the
container lid with fill tube onto the
material container.
(a)
(a)
1
OR
1
(b)
(c)
2
2 3