Wagner Power_Roller_Max - Manual (Page 5)

5 English
Setup (continued)
Variable speed dial:
Roller handle rest area:
1. Plug in the power cord. Turn the variable speed dial to
desired setting. No paint will flow until the motor has
been activated by the handle button (see Using the
handle button on page 6).
Use the carrying handle as a rest area for the roller handle and
arm when they are not in use.
NOTE - The roller handle should not be placed into the
handle rest area when it is attached to the extension! The
spatter shield can be used as a rest for the roller arm when
the extension is being used.
NOTE - During break periods, make sure that the roller is
not saturated with paint, or it will drip and accumulate in
the spatter shield.
The settings on the variable speed dial determine the flow rate of paint (1-9). The higher the setting, the higher the flow
rate. A setting of zero (0) means the unit is switched off.
2. Make sure the paint flow direction switch is set to
“PAINT” position.
9 1
PAINT
REVERSE