Waterloo F1881 - Manual (Page 4)

Process:
• Attach (2) Side Support Rail, as shown, using (2) M8-
1.25 x 16mm Carriage Bolt, (2) M8 Washer, and (2)
M8-1.25 Hex Lock Nut in each Side Support Rail.
• Finger tighten.
SIDE SUPPORT INSTALLATION
Items Needed:
Side Support Rail (Qty: 2)
M8-1.25 x 16mm Carriage Bolt (Qty: 4)
M8 Washer (Qty: 4)
M8-1.25 Hex Lock Nut (Qty: 4)
Process:
• Place Locking Top and Drawer Unit on its back on
packaging material as shown.
• Attach assembly from steps 1 through 4, using (12) M8-
1.25 x 16mm Carriage Bolt, (12) M8 Washer, and (12)
M8-1.25 Hex Lock Nut.
• The notches should be on the side with the label. Leave
holes in notches open for later assembly.
• Finger tighten.
TOP AND DRAWER UNIT ASSEMBLY
Items Needed:
Locking Top and Drawer Unit (Qty: 1)
M8-1.25 x 16mm Carriage Bolt (Qty: 12)
M8 Washer (Qty: 12)
M8-1.25 Hex Lock Nut (Qty: 12)
Process:
• Attach Handle to bottom set of holes using (2) M8-1.25
x 16mm Carriage Bolt, (2) M8 Washer, and (2) M8-1.25
Hex Lock Nut.
• Install (2) M8-1.25 x 16mm Carriage Bolt (In a Separate
Bag) in top set of holes using (2) M8 Washer and (2) /16-
18 Hex Lock Nut.
• Finger tighten.
HANDLE INSTALLATION
Items Needed:
Handle (Qty: 1)
M8-1.25 x 16mm Carriage Bolt (Qty: 2)
M8 Washer (Qty: 4)
M8-1.25 Hex Lock Nut (Qty: 4)
M8-1.25 x 16mm Carriage Bolt (Qty: 2) (In Separate Bag)
Notch
Label
Leave open for
later assembly
Packaging
material
Packaging
material
Hinge
Side Support Rail
Flange
on top
Nut
Bolt
4
Carriage Bolts
(In a separate bag)
Carriage Bolts