MagTek INTELLISTRIPE 50 - Manual (Page 15)

Section 2. Installation
9
CABLE CONNECTION
The PCB supports the use of a 10-pin, dual-row, 0.100” connector at the rear of the unit. (non-
locking). The pin list for the I/O Connector is shown in Table 2-2.
Table 2-2. Pin List for I/O Connector (J1)
Pin Number Signal Name Description
1 Landing Switch Signal
2 Landing Switch Ground*
3 SC Contact C1 Power
4 SC Contact C5 Ground
5 SC Contact C2 Reset
6 SC Contact C6 Program V
7 SC Contact C3 Clock
8 SC Contact C7 Data I/O
9 SC Contact C4 Reserved for Future Use**
10 SC Contact C8 Reserved for Future Use**
* Pin 2 of the I/O header is the ground side of the Landing switch.
It should be noted that pin 2 shares a common internal connection
to the ground signal on pin 4. See the diagram below for clarification.
** per ISO 7816
The pin list and mating connector for the flex cable are shown in Figure 2-3.
1
2
3
4
5
6
7
8
9
10
SC Contact C1
SC Contact C5
SC Contact C2
SC Contact C6
SC Contact C3
SC Contact C7
SC Contact C4
SC Contact C8
Landing Switch
Smartcard
Connector Block
(Normally Open)
10-pin I/O Header
User-defined
Host
Electrical
Interface