MagTek PORT POWERED - Manual (Page 2)

ii
Copyright
©
1998-2010
MagTek
®
, Inc.
Printed in the United States of America
Information in this document is subject to change without notice. No part of this document may
be reproduced or transmitted in any form or by any means, electronic or mechanical, for any
purpose, without the express written permission of MagTek, Inc.
MagTek is a registered trademark of MagTek, Inc.
REVISIONS
Rev Number Date Notes
1 7 Dec 98 Initial Release
2 29 Mar 99 Title: Deleted Dual Head in order to add single head units; Section 1: Added 6 part
numbers and Windows Driver reference, added transfer rates to specification;
Section 2: Added Molex part number, added note to Table 2-1, removed connector
J5 from Figure 2-2, and added note for optional cable; Section 3: Added Figure
3-4, Timing.
3 14 Jun 99 Title: Dropped MT-215 and RS-232; Sec 2, added Table 2-2, Pin List, and changed
Figure 2-2 , added Pin Numbers for optional Cable 21040077.
4 1 Dec 99 Section 2: Updated J4 Connector Table.
5 11 Jan 00 Section 1: added Track 2-3 version to Table 1-1; Section 2: Clarified Fig 2-2 for
connector uses with Tracks. Remove cable 21051498; add cables 21051499 and
21041469. Section 3: added Track 2-3 version to “Reader to Host Formats” and to
“Timing for ID sign-on and Transmission Bursts.”
6 14 Sep 00 Section 1: Specifications, changed all cm dimensions to mm. Corrected
temperature ranges. Written to SI, International System of Units.
7 6 Oct 00 Section 1: Editorial; Section 3: Qualified Inquiry command for two models.
8 01 Jan 01 Front Matter: Changed copyright date; Changed warranty from 90 days to one
year; added agency approvals to current manual.
9 20 Mar 01 Front Matter: Added Address for Warranty RMA. Changed Agency approvals to
Class B. Section 2: Fig 2-1, Added to Back View “of Bezel”. Section 3: Added
Transmission examples. Added Appendix A. Bezel Design
10 01 Aug 01 Front Matter: Editorial corrections to CE and UL/CUL.
11 27 Nov 01 Sec 2, Fig 2-2: Added extended bezel illustration; Appendix A: Added extended
bezel mechanical drawing
12 09 Sep 02 Front Matter: added ISO line to logo, changed Tech Support phone number, added
new warranty statement. Editorial throughout. Sec 1: added two P/Ns to
Configurations, added statement to unbuffered mode. Sec 3: Editorial; Clarified
Table 3-2. Added new Appendix A, Optional Firmware Features. Changed
Appendix A to B.
13 21 Feb 03 Sec 2: Note added after Figure 2-3 stating cable with tie wrap adds approximately
.25 inch to length of unit.
14 13 Mar 03 Replaced some fonts so manual would print on all printers.
15 13 May 03 Front Matter: added ISO line to logo, changed Tech Support phone number, added
new warranty statement.
16 26 Jun 03 Changed operating temperature to before (32
o
F) and after (-4
o
F) 1 Nov 03
shipping date.
17 9 May 07 Removed 21065131 & 21066008; modified specifications to reflect change-over to
21063619.
18 25 May 09 Added 21065142. Updated Limited Warranty and Agency approvals.
19 25 Oct 10 Clarified the PCB listing in Table 1-2