MagTek MAGTEK - Manual (Page 43)

Section 3. Installation
37
Removing a Device Instance from a Command Line – RS-232
Use the following command syntax to remove an existing device instance.
mcpcfg r
is a name of the device instance to be removed. This name was specified
with the mcpcfg a command when the device was added.
For Windows NT Administrator privilege is required to execute this command.
Example:
mcpcfg r IntelliStripe
The informational and diagnostic messages displayed by this command can be suppressed by
using the “quiet” version:
mcpcfg rq
Removing a Device Instance from a Command Line – USB
The USB device instances are automatically removed when the device is physically removed
from the system. Please stop the device by clicking on the “Safely Remove Hardware” Icon on
the task bar first before physically removing it from the USB port.
Displaying the List of Device Instances from Command Line
The following command displays the names of all configured device instances:
mcpcfg l
For Windows NT this command may be used without Administrator privilege.
Displaying Device Instance Properties from Command Line
To display the current settings for a device instance use the following command:
mcpcfg p
where:
is a name of the device instance. This name was specified with the mcpcfg
a command when the device was added. To see a list of existing device
instance names, use mcpcfg l.