Lyndex-Nikken Shrink Fit Machine Instructions - Manual (Page 16)

ELCO Shrink fit unit Start.2 27/04/2010
Page 16/19
light « induction »
Switched off : no power, the inductor is not heating
fixed : The inductor heats the attachment (see §2 safety)
flashing : « default »
Check that the tool holder is made of material compatible
with the shrink fit unit
light « cooling »
Switched off : cooling is not operating, or was stopped automatically after having
operated for 15 minutes
fixed : cooling is operating since less than 2 minutes ; it is not possible to
stop it
flashing : cooling is operating since more than 2 minutes ; it is possible to
stop it
All the lights are flashing : it is a problem between the
generator and the remote control
Switch the unit off, check the connection of the sub-D plug
and if the screws are well tightened.
For any other dysfunction not mentioned in this document, please contact the
manufacturer’s after-sales service.
In any case, NEVER OPEN THE UNIT without being sure that the unit is switched
off (disconnected from electrical power) : DANGEROUS VOLTAGE.