AMICA OKC6767I EN - Manual (Page 5)

5
To install the hood proceed as follows:
1.
Hang the hood body,
2. Connect the hood to the ventilation duct,
3. Establish the height of the telescoping column of the
masking cover,
4. Install the wall hanger at the appropriate level,
5. Install the complete set of masking covers,
6. Connect the hood to the power supply network.
1. Draw a vertical line on the wall to mark the centre of the cooker. Hold the body
of the cooker hood against the wall and arrange it symmetrically with the
centre line, keeping a distance of at least 790 mm between the openings in
the hood body and the hotplate. Holding it level, mark the spacing of the
mounting holes on the wall,
2. Drill the holes marked on the wall using a drill head with a diameter equal to
that of the rawlplugs supplied, then hammer the plugs in and screw the body
of the hood onto the wall,
1. If necessary, install the appropriate air outlet
leading to a ventilation duct ,
2. Place the telescopic column of the frame A and B
onto the hanging hood (fig. 1)
3. Slide the upper frame (fig.3) to the required height,
mark its maximum span on the centre line, then
remove the column of the frame,
4. Hold hanger D of the upper frame (fig. 3) against
the marked centre line, then mark the positions of
the hanger’s mounting holes on the wall and attach
it. Replace the column of the frame and screw it
onto the upper hanger of the frame (fig. 3 pt B & C)
using the appropriate screws
5. Connect the hood to the electricity mains. Fig. 3
V Installation
1.1. Mounting the Wall Hanger
1.2. Assembling the Hood