Videotec NXM - Manual (Page 6)

EN - English - I
nstruc
tions manual
4
6 Assembling and
installing
g h Only specialised personnel should be
allowed to assemble and install the device.
6.1 Installation
6.1.1 How to open the housing
To open the housing, unscrew the bolts on the front
bottom, using the hexagonal spanner supplied.
Fig. 01
Remove the bottom of the housing.
Fig. 02
6.1.2 How to install the camera
This chapter described how to install the camera into
the housing.
Open the housing as described previously.
Fit the camera on the slide, using the insulating plate
and the supplied 1/4” screw. If necessary, use the
spacers to position the camera and optics correctly.
Fig. 03
5 Preparing the product
for use
g h Any change that is not expressly approved
by the manufacturer will invalidate the
guarantee.
5.1 Contents and unpacking
When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
Keep the packaging in case you need to send the
product for repairs.
Check the contents to make sure they correspond
with the list of materials as below:
• NXM housing
• Housing equipment:
• Allen wrench
• Spacers
• Screws and washers
• Screws for camera
• Instructions manual
5.2 Safely disposing of
packaging material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
Bear in mind that if the material has to be returned
due to a fault, using the original packaging for its
transport is strongly recommended.