Kenwood DNX5210BT - Manual (Page 29)

29
DNX7210BT/DNX5210BT/DNX5510BT/DNX4210BT
Connecting wires to terminals (2)
Connect to the vehicle’s
parking brake detection
switch harness.
PRK SW
REVERSE
For best safety, be sure to connect the
parking sensor.
Connect to vehicle’s reverse lamp harness
when using the optional rear view camera.
Light Green (Parking sensor wire)
Accessory 1
Purple/White (Reverse sensor wire)
To use the steering wheel remote control feature,
you need an exclusive remote adapter (not
supplied) matched to your car.
Light Blue/Yellow
(Steering remote control wire)
Brown (Mute control wire)
Blue/White (Power control/
Antenna control wire)
Connect to the terminal that is grounded when
either the telephone rings or during conversation.
To use the Mute feature, you need to hook up this
wire to your telephone by using a commercial
telephone accessory.
Depending on what antenna you are using, connect
either to the control terminal of the motor antenna,
or to the power terminal for the booster amplifier
of the film-type antenna. (Max. 300mA, 12V)
If no connections are made,
do not let the cable come out from the tab.
To steering remote
REMOTE CONT
MUTE
ANT.
CONT
P. CONT
STEERING WHEEL
REMOTE INPUT
B59-2101-00_00_12DNX7_QSG_E.indd 29 11/12/02 14:20