Kenwood DNX5210BT - Manual (Page 28)

28
Quick Start Guide
Connection
Connecting wires to terminals (1)
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
ILLUMI
Cooling fan Cooling fan
Fuse
(15A)
Fuse
(15A)
Accessory 1
Accessory 8 Accessory 6 Accessory 6 Accessory 8
FM/AM antenna input
Accessory 8:
Bluetooth Microphone
Accessory 6: GPS Antenna
A B C
C: Red
(Ignition wire)
A: Black
(Ground wire)
B: Yellow
(Battery wire)
Orange/White
(Dimmer control wire)
Orange
/White
2 WARNING for Connecting the ISO Conncetor
The pin arrangement for the ISO connectors
depends on the type of vehicle you drive. Make
sure to make the proper connections to prevent
damage to the unit. The default connection for the
wiring harness is described in (1) below. If the ISO
connector pins are set as described in (2), make the
connection as illustrated. Please be sure to reconnect
the cable as shown (2) below to install this unit to
the Volkswagen vehicles etc.
(1): Default setting
The red (A-7 pin) of the vehicle’s ISO connector is
linked with the ignition, and the yellow (A-4 pin) is
connected to the constant power supply.
(2)
The red (A-7 pin) of the vehicle’s ISO connector is
connected to the constant power supply, and the
yellow (A-4 pin) is linked to the ignition.
Red (Ignition cable)
Unit Vehicle
Yellow (Battery cable) Yellow (A-4 pin)
Red (A-7 pin)
Red (Ignition cable)
Unit Vehicle
Yellow (Battery cable) Yellow (A-4 pin)
Red (A-7 pin)
B59-2101-00_00_12DNX7_QSG_E.indd 28 11/12/02 14:20