Kenwood DNN9250DAB - Manual (Page 140)

139
Return to the Top page
Controlling Audio
Loudness
Set the amounts of boost of low and high
tones.
DNN9250DAB/ DNR8025BT: “OFF”, “Low”, “High”
DNN6250DAB: “OFF”, “ON”
SW Level
Adjust the subwoofer volume. This setting is
not available when subwoofer is set to “None”.
See
Speaker setup (P.135) .
Zone Control
You can select different sources for both
front and rear positions in the vehicle.
1
Touch [ ] on any screen.
2
Touch [Audio].
Audio screen appears.
3
Touch [Zone Control].
Zone Control screen appears.
4
Touch [Dual Zone].
5
Set each source as follows.
[ D] (Front Source, Rear Source)
Select the audio source for each.
[
S], [R] (Rear VOL.)
Adjust the rear channel volume.
[Single Zone]
Touch to turn off the dual zone function.
NOTE
• When the rear speaker sound is switched, the
audio source that is output at the AV OUTPUT
terminal is also switched to the same source.
• When the dual zone function is set to on, the
following functions are not available.
–Output from the subwoofer
–Subwoofer Level/Bass Boost (P.137)
–Equalizer Control/Sound Effect/Listening
Position (P.138, 140, 142)
–DSP Bypass Control/Speaker Setup/Car Type
Setup (P.137, 135, 136)