Kenwood TK-7160E - Discontinued - Manual (Page 16)

10
BASIC OPERATIONS
S
WITCHING
P
OWER
ON/ OFF
Press the switch to switch the transceiver ON.
• A beep sounds.
• If programmed, the TK-7160/ TK-8160 transceiver will momentarily display an
8-character power-on message.
• If the Transceiver Password function is programmed, “ ” (TK-7160/ TK-8160)
or “ ” (TK-7162/ TK-8162) will appear on the display when the power is turned ON.
Refer to “Transceiver Password”, below.
Press the switch again to switch the transceiver OFF.
■ Transceiver Password
To enter the password:
1 Press the and keys to select a digit.
2 Press the C> key to accept the entered digit and move to the next digit.
• Press the A key to delete an incorrect character (TK-7160/ TK-8160). Press
and hold the A key to delete all entered characters.
• Repeat steps 1 and 2 to enter the entire password.
3 Press the S key to confirm the password.
• If you enter an incorrect password, an error tone sounds and the transceiver
remains locked.
To enter the password using an optional DTMF keypad:
1 Press the DTMF keys corresponding to the password digits.
• Press the A or DTMF # key to delete an incorrect character (TK-7160/
TK-8160). Press and hold the A or DTMF # key to delete all entered
characters.
2 Press the S or DTMF key to confirm the password.
• If you enter an incorrect password, an error tone sounds and the transceiver
remains locked.
A
DJUSTING THE
V
OLUME
Press the Volume Up key to increase the volume. Press the Volume Down key
to decrease the volume.
If Squelch Off has been programmed onto a key, you can use that function to
listen to background noise while adjusting the volume level.