Kenwood DNX7250DAB - Manual (Page 84)

83
Return to the Top page
Setting Up
View Camera Control
You can set up display when a CMOS-3xx
Series view camera is used.
1
Press the button for 1second.
Camera view screen appears.
2
Adjust each item as follows.
3 2 1
1 Guideline
Touching each time turns on or off the
guideline display alternately.
2 Switching the View Camera
Touching each time changes between the
front view camera and rear view camera.
3 Angle
Touching each time changes camera angles in
the following order:
Super wide view/ Wide view/ Overhead view/
Wide view + Top view/ Corner view
NOTE
• The video camera controls described above
may not be operable depending the connected
cameras.
• [AUD Key Longer than 1 Second] must be set to
“R-CAM”/ “CAM”. See User interface (P.84)
System Setup
NOTE
• Each operation in this section can be started from
the multi function menu.
1
Touch [Menu] on any screen.
TOP Menu screen appears.
2
Touch [SETUP].
3
Touch [System].
System Menu screen appears.
See the following section for each setting.
• Set up the user interface (P.84)
• Adjust touch panel (P.86)
• Set up security (P.86)
• Set up memory (P.88)