Preparation using ground coffee, Preparing milk froth and warm milk – Siemens TE803209RW User Manual
Page 20
16
en
Preparation using
ground coffee
This fully automatic espresso machine can
also be operated using ground coffee (not
instant coffee powder).
Note: The aromaDouble Shot function
cannot be used when coffee is prepared
using ground coffee.
Drink preparation without milk
The appliance must be ready for use.
● Place the pre-warmed cup(s) under the
coffee outlet
9.
● Select the required
Espresso
À
or
Coffee
Á
by turning the rotary knob
6.
● Open the powder compartment
18.
● Pour in no more than 2 level measuring
spoons
14 of ground coffee.
¡
Warning!
Do not use whole beans or instant coffee.
● Close the powder compartment
18.
● Press the
start button 8.
The coffee is brewed and then dispensed
into the cup(s).
Note: Repeat the procedure for another cup
of coffee. If coffee is not dispensed within
90 seconds, the brewing chamber emp-
ties automatically to avoid an overflow. The
appliance rinses.
Drink preparation with milk
The appliance must be ready for use.
● Place the suction pipe
10d of the milk
frother
10 deep in the milk container 26.
● Swivel the coffee outlet
9 to the right until
it clicks into place.
● Place the pre-warmed cup or glass under
the coffee outlet
9 and milk frother 10.
● Select the required
Macchiato
Å
or
Cappuccino
Æ
by turning the rotary
knob
6.
● Open the powder compartment
18.
● Pour in no more than 2 level measuring
spoons
14 of ground coffee.
¡
Warning!
Do not use whole beans or instant coffee.
● Close the powder compartment
18.
● Press the
start button 8.
First milk is delivered into the cup or glass.
Then the coffee is brewed and dispensed
into the cup or glass.
Important: Dried milk residue is difficult
to remove, so the milk frother
10 must be
cleaned with lukewarm water immediately
after use (see “Cleaning the milk system”).
Note: Repeat the procedure for another
cup of coffee / milk drink. If coffee is not
dispensed within 90 seconds, the brewing
chamber empties automatically to avoid an
overflow. The appliance rinses.
Preparing milk froth and
warm milk
¡
Risk of burns!
The milk frother
10 gets very hot. After use,
allow to cool down first before touching.
The appliance must be ready for use.
● Place the suction pipe
10d of the milk
frother
10 deep in the milk container 26.
● Place the pre-warmed cup or glass under
the outlet of the milk frother
10.
● Select the required setting
Milk froth
È
or
Warm milk
É
by turning the rotary
knob
6.
● Press the
start button 8.
Milk froth or warm milk flows from the outlet
of the milk frother
10.
Press the
start button 8 again to cut the
process short.