Siemens LF959RA50 - Manual (Page 16)

16
dot flashes in the display. After this
period the fan switches off
automatically.
Lighting:
‰
The light can be switched on at any
time, even though the fan is switched
on.
Remote control:
The remote control is set up by
the manufacturer. If the remote
control is not controlling motor or
light nearby the cooker hood,
please do the following.
Set up of the remote control.
Keep pressing the “+” button of
the remote control and then connect the
cooker hood, to confirm that the remote
control has been recognized a long beep
is issued. If you do not hear the acoustic
signal within 30 seconds, please repeat
the steps as described.
Functions of the remote control.
The +, -, and Light Push button have
the same functions as on the controls of
the hood.
The : Push button has the same
function as the .
Interval Function:
A specific function of this appliance is the
Interval Function which consists in
activating the motor in automatic way 10
minutes each hour at the speed flashing in
the display.
This function can be activated on the
control of the hood or by remote control.
Interval Function by controls:
‰
Keep pressing at the same time the O
and + push buttons, then release
them: the display will show the 1;
‰ Keep pressing at the same time the +
push button, the display will show
the following for the speeds of the
motor 2→3→1→2 …;
‰ Keep pressing at the same time the O
and + push buttons to confirm the
speed for the motor you wish for the
interval function.
Interval Function by remote control:
‰ Keep pressing the : push button.
The display will show 1;
‰ Keep pressing the + push button, the
display will show the following for the
speeds of the motor 2→3→1→2 …;
‰ Press the push button to confirm
the speed of the motor for the interval
function.
When you are in the setting phase, if the
interval function shown is not confirmed
within some seconds, then you get out of
the setting mode for the interval function.
By pressing any push button, light
excluded, the interval function is excluded.
The remote control has a battery – When
the battery is exhausted you need to:
1. loosen the 2 screws on the rear part
and remove the cover.
2. take the battery out and replace it with
one with the same characteristics.
3. Close the cover again and tighten the
screws.
Follow National norms for waste disposal
of exhausted batteries.
Filters and maintenance
Grease filters:
Metal filters are used to trap the greasy
element of the vapours that develop
during cooking.
The filter mats are made from non-
combustible metal.
Caution:
As the filter becomes more and more
saturated with grease, not only does the
risk of catching fire increase, but the