Kenwood TM-D710GA - Manual (Page 11)

MEMORY CH-1
MEMORY CHANNELS
In Memory channels, you can store frequencies and related data that you often use. Then you need not reprogram the data every time.
You can quickly recall a programmed channel by simple operation. A total of 1000 Memory channels are available for bands A and B.
SIMPLEX & REPEATER OR ODD-SPLIT MEMORY
CHANNEL?
You can use each memory channel as a simplex & repeater
channel or as an odd-split channel. Store only one frequency to
use as a simplex & repeater channel or two separate frequencies
to use as an odd-split channel. Select either application for each
channel depending on the operations you have in mind.
Simplex & repeater channels allow:
• Simplex frequency operation
• Repeater operation with a standard offset (if an offset
direction is stored)
Odd-split channels allow:
• Repeater operation with a non-standard offset
The data listed below can be stored in each Memory channel:
Parameter
Simplex &
Repeater
Odd-split
Receive frequency
Yes
Yes
Transmit frequency Yes
Receive frequency step
size
Yes
Yes
Transmit frequency step
size
Yes
Offset direction Yes No
Tone ON/OFF Yes Yes
Tone frequency Yes Yes
CTCSS ON/OFF Yes Yes
CTCSS frequency Yes Yes
DCS ON/OFF Yes Yes
DCS code Yes Yes
Reverse ON/OFF Yes No
Memory channel lockout Yes Yes
Memory channel name Yes Yes
Modulation/
Demodulation mode
Yes Yes
STORING SIMPLEX AND STANDARD REPEATER
FREQUENCIES
1 Press [VFO] to enter VFO mode.
2 Rotate the Tuning control to select your desired frequency.
• Additionally, you can press the microphone [UP]/[DWN] keys to
select a frequency.
3 Set up any additional data desired for the frequency.
• Offset direction, Tone ON/OFF, Tone frequency, CTCSS ON/OFF,
CTCSS frequency, DCS ON/OFF, DCS code, etc.
4 Press [F].
• A memory channel number appears.
5 Rotate the Tuning control to select your desired channel
number.
• When the selected channel number does not have stored data,
the “ ” icon appears. When the channel does have stored data,
the “ ” icon appears.
• Additionally, you can press the microphone [UP]/[DWN] keys to
select a channel.
6 Press [M.IN] to store the data in the selected Memory
channel.
Note: If you store the data in a Memory channel that already has data stored in
it, the old data will be cleared and the new data will be stored.
■ Call Channel Memory (Simplex)
The Call channel can be used to store any frequency and
related data that you will recall often. You may want to
dedicate the Call channel as an emergency channel within
your group.
To store a simplex frequency and related data as the Call
channel instead of in a Memory channel, after step 4 (above),
press [C.IN].
Note: Storing new data in the Call channel will clear the old data. (The Call
channel itself cannot be cleared, but data can be replaced with new data.)