Kenwood RC-D710 - Manual (Page 27)

EchoLink-2
■ Selecting a Transmit Speed
Some repeaters may not respond correctly if a code is
transmitted at fast speed. If this happens, change the
EchoLink transmission speed from FAST (default) to
SLOW.
1 Enter Menu mode and access Menu 205.
2 Set the speed to FAST or SLOW.
SETTING UP EchoLink Sysop MODE
Connect the TM-V71 to a personal computer to use the
system as a node station for EchoLink relaying.
When connecting to a personal computer and using the
EchoLink Sysop mode, the hard flow control operation
RTS and CTS computer terminals operate the same as
and are changed with the SQC (squelch control signal
output to the computer) and PKS (transmit control signal
input from the computer) data terminals.
The current band becomes the same as the data band
which is selected in menu No. 517, regardless of the
transmission band and operation band.
Use the PG-5H (interface cable kit) when connecting to a
personal computer.
1 Turn the transceiver power OFF.
2 Press [PF2] + Power ON to turn EchoLink Sysop
Mode ON.
• The icon appears on the display when EchoLink Sysop
mode is ON.
• When the audio signal is output to the PC side, the
icon blinks.
• To turn EchoLink Sysop Mode OFF, press [PF2] + Power
ON again.
EchoLink Sysop Mode ON EchoLink Sysop Mode OFF
PC
terminal
PC
PC
terminal
PC
TxD g RxD TxD g RxD
RxD f TxD RxD f TxD
SQC g CTS RTS g CTS
PKS f RTS CTS f RTS
GND n GND GND n GND
Data communications cable
Serial communications cable
To PC audio terminal
Pink: To microphone input terminal
Green: To line out terminal
To PC 9-pin D-SUB
terminal