Kenwood NX-420 User Manual

Page 31

■

Stun Code

This function is used when a transceiver is stolen or lost.

When the transceiver receives a call containing a stun

code, the transceiver becomes disabled. The stun code is

cancelled when the transceiver receives a call with a revive

code.

EMErGENCy CAllS

If your transceiver has been programmed with the Emergency

function, you can make emergency calls.
1 Press and hold the key programmed as [Emergency].

• Ask your dealer for the length of time necessary to hold this

key before the transceiver enters Emergency mode.

• When the transceiver enters Emergency mode, it will change to

the Emergency channel and begin transmitting based on how it

is set up by your dealer.

2 To exit Emergency mode, press the [Emergency] key

again.

• If the Emergency mode completes a preset number of cycles,

Emergency mode will automatically end and the transceiver

will return to the zone and channel that was in use before

Emergency mode was entered.

Note:
◆

Your dealer can set the transceiver to emit a tone when

transmitting in Emergency mode.

◆

Your dealer can set the transceiver to emit tones and received

signals as normal, or mute the speaker during Emergency

operation.

■

Activity Detection

Press the key programmed as

[Activity Detection], to

toggle Activity Detection ON and OFF. If an event occurs

while Activity Detection is enabled, the transceiver enters

Emergency mode.