Basic operations – Kenwood NX-420 User Manual

Page 20

BASIC OPErATIONS

SwITCHING POwEr ON/OFF

Turn the

Power switch/ Volume control clockwise to switch the

transceiver ON.
Turn the

Power switch/ Volume control counterclockwise fully

to switch the transceiver OFF.

■

Transceiver Password (Types I and II Only)

If your transceiver is password protected, you must first

enter the password before you can use the transceiver.
1 Rotate the Selector to select the first digit of the

password.

2 Press the S

key to accept the entry and move to

the next digit.

• Press the

A or # key to delete an incorrect digit.

3 Repeat steps 1 and 2 to enter the entire password.

• The password can contain a maximum of 6 digits.

4 Press the S

key to confirm the entered password.

• If you enter an incorrect password, an error tone sounds

and the transceiver remains locked.

ADJUSTING THE vOlUME

Rotate the

Power switch/ Volume control to adjust the volume.

Clockwise increases the volume and counterclockwise

decreases it.

SElECTING A ZONE AND CHANNEl/GrOUP ID

Select the desired zone using the key programmed as

[Zone

Select] or [Zone Up/Down]. Each zone contains a group of

channels.
Select the desired channel/group ID using the

Selector knob

(default). Each channel/group ID is programmed with settings

for transmitting and receiving.