Getting started – Kenwood KMR-M308BT User Manual
Page 4
4
Data Size:
B6L (182 mm x 128 mm)
Book Size:
B6L (182 mm x 128 mm)
GETTING STARTED
Set the initial settings
1 Press B SRC to enter STANDBY.
2 Press the volume knob to enter [FUNCTION].
3 Turn the volume knob to make a selection (see the following table), then press
the knob.
4 Press and hold
to exit.
To return to the previous setting item or hierarchy, press
.
Default: XX
AUDIO CONTROL
SWITCH PREOUT
REAR/ SUB-W: Selects whether rear speakers or a subwoofer are connected to
the line out terminals on the rear (through an external amplifier).
SP SELECT
OFF/ 5/4/ 6 × 9/6/ OEM: Selects according to the speaker size (5 inches or
4 inches, 6×9 inches or 6 inches) or OEM speakers for optimum performance.
TUNER SETTING
PRESET TYPE
NORMAL: Memorizes one station for each preset button in each band (FM1/
FM2/ FM3/ AM). ; MIX: Memorizes one station for each preset button, regardless
of the selected band.
SYSTEM
KEY BEEP
ON: Activates the keypress tone. ; OFF: Deactivates.
SOURCE SELECT
PANDORA SRC*
ON: Enables PANDORA in source selection. ; OFF: Disables. ( 8)
IHEART SRC*
ON: Enables IHEARTRADIO in source selection. ; OFF: Disables. ( 9)
BUILT-IN AUX
ON: Enables AUX in source selection. ; OFF: Disables. ( 8)
F/W UPDATE
UPDATE SYSTEM/ UPDATE BT
F/W UP xx.xx
YES: Starts upgrading the firmware. ; NO: Cancels (upgrading is not activated).
For details on how to update the firmware, see: www.kenwood.com/cs/ce/
* For
KMM-BT308U
/
KMR-M308BT
.
3
Cancel the demonstration
When you turn on the power (or after you reset the unit), the
display shows: “CANCEL DEMO” “PRESS” “VOLUME KNOB”
1 Press the volume knob.
[YES] is selected for the initial setup.
2 Press the volume knob again.
“DEMO OFF”
appears.
For
KMR-M308BT
, [DEMO OFF] is selected initially.
Set the clock
1 Press the volume knob to enter [FUNCTION].
2 Turn the volume knob to select [CLOCK], then press the knob.
3 Turn the volume knob to select [CLOCK ADJUST], then press the knob.
4 Turn the volume knob to make the settings, then press the knob.
Day Hour Minute
5 Turn the volume knob to select [CLOCK FORMAT], then press the
knob.
6 Turn the volume knob to select [12H] or [24H], then press the knob.
7 Press and hold
to exit.
To return to the previous setting item or hierarchy, press
.
While in clock display screen...
Press and hold DISP SCRL to enter clock adjustment mode
directly.
Then, perform step
4 above to set the clock.
1
2
EN_KMM_BT308U_KN_2.indd 4
EN_KMM_BT308U_KN_2.indd 4
8/11/2013 3:46:54 PM
8/11/2013 3:46:54 PM