Kenwood KMR-M308BT User Manual

Page 12

Data Size:

B6L (182 mm x 128 mm)

Book Size:

B6L (182 mm x 128 mm)

Bluetooth test mode

You can check the connectivity of the supported profile between the
Bluetooth device and the unit.
• Make sure there is no Bluetooth device connected.
1 Press and hold

“PLEASE PAIR YOUR PHONE” appears.
2 Search and select this unit model name (KMM-BT3**U/ KMM-BT3**/

KMR-M3**BT) on the Bluetooth device.

3 Operate the Bluetooth device to confirm pairing.
“TESTING” flashes on the display.

The connectivity result (OK or NG) appears after the test.
PAIRING: Pairing

status

HF CNT:

Hands-Free Profile (HFP) compatibility

AUD CNT: Advanced Audio Distribution Profile (A2DP) compatibility
PB DL:

Phonebook Access profile (PBAP) compatibility

• To cancel check mode, press and hold B SRC to turn off the unit.

Bluetooth mobile phone

Do this

Receive a call

Press

or the volume knob or one of the

number buttons (1 to 6) (or press

RC-406).

• All the button illumination flash when there

is an incoming call.

• When

[AUTO ANSWER] is set to the selected

time, the unit answers incoming call
automatically. ( 14)

Reject an incoming
call

Press B SRC (or press

on RC-406).

End a call

Press

or B SRC (or press

on RC-406).

Pair a Bluetooth device

When connecting a Bluetooth device to the unit for the first time,
perform pairing between the unit and the device. Once the pairing is
completed, the Bluetooth device will remain registered in the unit even if
you reset the unit.
• Up to five devices can be registered (paired) in total.
• A maximum of two Bluetooth phones and one Bluetooth audio device

can be connected at any time.

• This unit supports Secure Simple Pairing (SSP).
• Some Bluetooth devices may not automatically connect to the unit

after pairing. Connect the device to the unit manually. Refer to the
instruction manual of the Bluetooth device for more information.

1 Press B SRC to turn on the unit.
2 Search and select this unit model name (KMM-BT3**U/ KMM-BT3**/

KMR-M3**BT) on the Bluetooth device.

“PAIRING” “PASS XXXXXX” Device name “PRESS” “VOLUME

KNOB” scrolls on the display.

3 Press the volume knob to start pairing.
“PAIRING OK” appears when pairing is completed and “BT” will light

up when the Bluetooth connection is established.

• For some Bluetooth devices, you may need to enter the Personal

Identification Number (PIN) code immediately after searching.

• Pairing request (via Bluetooth) is automatically activated if an iPhone/

iPod touch is connected through the USB input terminal. (Applicable
only if [AUTO PAIRING] is set to [ON].) ( 15)

Press the volume knob to pair once you have confirm the device name.

BLUETOOTH®

EN_KMM_BT308U_KN_2.indd 12

8/11/2013 3:46:56 PM