Audio settings – Kenwood KMR-M308BT User Manual

Page 17

ENGLISH |

Data Size:

B6L (182 mm x 128 mm)

Book Size:

B6L (182 mm x 128 mm)

AUDIO SETTINGS

While listening to any source...
1 Press the volume knob to enter [FUNCTION].
2 Turn the volume knob to select [AUDIO CONTROL], then press the

knob.

3 Turn the volume knob to make a selection (see the following table),

then press the knob.

Repeat

step

3 until the desired item is selected or activated.

4 Press and hold

to exit.

(or

using

RC-406)

1 Press AUD to enter [AUDIO CONTROL].
2 Press J / K to make a selection, then press ENT IW.

To return to the previous setting item or hierarchy, press

Default: XX

SUB-W LEVEL

–15 to +15 (0): Adjusts the subwoofer output level.

BASS LEVEL

–8 to +8 (+6):

Adjusts the level to memorize for each source.
(Before making an adjustment, select the source you
want to adjust.)

MID LEVEL

–8 to +8 (+5):

TRE LEVEL

–8 to +8 (0):

PRESET EQ

DRIVE EQ/ TOP40/ POWERFUL/ ROCK/ POPS/ EASY/ JAZZ/ NATURAL/
USER: Selects a preset equalizer suitable to the music genre. (Select
[USER] to use the customized bass, middle, and treble settings.)
[DRIVE EQ] is a preset equalizer that reduces noise from the road.

BASS BOOST

LV1

/ LV2/ LV3: Selects your preferred bass boost level. ; OFF: Cancels.

LOUDNESS

LV1/ LV2: Selects your preferred low and high frequencies boost to
produce a well-balanced sound at a low volume level. ; OFF: Cancels.

SUBWOOFER SET ON: Turns on the subwoofer output. ; OFF: Cancels.

LPF SUBWOOFER THROUGH: All signals are sent to the subwoofer. ; 85HZ/ 120HZ/

160HZ: Audio signals with frequencies lower than 85 Hz/ 120 Hz/ 160 Hz
are sent to the subwoofer.

SUB-W PHASE

REVERSE (180°)/ NORMAL (0°): Selects the phase of the subwoofer
output to be in line with the speaker output for optimum performance.
(Selectable only if a setting other than [THROUGH] is selected for
[LPF SUBWOOFER].)

FADER

R15 to F15 (0): Adjusts the rear and front speaker output balance.

BALANCE

L15 to R15 (0): Adjusts the left and right speaker output balance.

VOLUME OFFSET
(Default: 0)

–8 to +8 (for AUX) ; –8 to 0 (for other sources): Presets the volume
adjustment level of each source. (Before adjustment, select the source
you want to adjust.)

SOUND RECNSTR
(Sound
reconstruction)

ON: Creates realistic sound by compensating the high-frequency
components and restoring the rise-time of the waveform that are lost in
audio data compression. ; OFF: Cancels.

• [SUB-W LEVEL]/ [SUBWOOFER SET]/ [LPF SUBWOOFER]/ [SUB-W PHASE] is

selectable only if [SWITCH PREOUT] is set to [SUB-W]. ( 4)

• [SUB-W LEVEL]/ [LPF SUBWOOFER]/ [SUB-W PHASE] is selectable only if

[SUBWOOFER SET] is set to [ON].

EN_KMM_BT308U_KN_2.indd 17

8/11/2013 3:46:56 PM