Dake Model HV 200 - Hydraulic - Manual (Page 2)

Dake Tube Bender manual 08212009 2
Thank you for buying Dake!!!!
We hope you enjoy many years of using your New Dake Tube Bender. If after reading
this manual you still have any questions please give us a call, e-mail or stop by for a
factory tour.
www.dakecorp.com
724 Robbins Road
Grand Haven, MI 49417
Phone: 616-842-7110 800-937-3253
CAUTION!!!
Read and understand all warnings, cautions, attentions and instructions before operating
this equipment.
CAUTION general
When working always pay attention and be alert. Be careful. Be aware of possible
Hazards.
CAUTION regulations
Observe the law and regulations. Check local regulations to properly dispose of oil and/or items
that have been in oil to dispose of properly.
ATTENTION tools
Always check that your tools are in good condition and that the tools are suitable for the work to
make (ex. don’t use the pliers as hammers etc.)
ATTENTION tampering
It is severely forbidden to modify or to tamper with parts that can alter the
standard working conditions.
CAUTION operator
For no reason whatsoever must the operator have their hands in the area of the piece being bent
during the pressing operation.
CAUTION operator
Tube being bent must be at least as long as the follower bar. Shorter material lengths could result
in the follower bar flying out the rear of the work area.
CAUTION Air
Do not exceed 100 psi damage to the pump will occur.
According to new legislation, the employer will have to check that the
operator has understood these notices.
THIS MACHINE IS DESTINED ONLY FOR THE USE IT HAS BEEN DESIGNED
FOR, ANY OTHER USE IS TO BE CONSIDERED IMPROPER AND
THEREFORE THE MANUFACTURER CANNOT BE HELD LIABLE FOR ANY
DAMAGE CAUSED BY ANY IMPROPER USE OR USE NOT EXPRESSLY
MENTIONED IN THIS USER’S MANUAL.