Dake Model Cut 250 - Manual (Page 7)

7
CUT 250 CUT 250 CUT 250 CUT 250 CUT 250
REGULATING
THE
MACHINE
7.1 - Disk head
- The devices do not require any particular adjustments.
7.2 - Vice
- The devices do not require any particular adjustments.
5
The cropper is now ready to start work, bearing in mind that the
CUTTING SPEED and the TYPE of DISC - combined with a
suitable descent of the head - are of decisive importance for
cutting quality and for machine performance (for further details
on this topic, see below in the chapter on “Material
classification and choice of disks”).
- When starting to cut with a new disk, in order to safeguard
its life and efficiency, the first two or three cuts must be
made while exerting a slight pressure on the part, so that
the time taken to cut is about double the normal time (see
below in the chapter on “Material classification and choice
of disks” in the section on
Running in the disk).
4
3
7
2
7.3 - Regulating arm blockage
- If there is insufficient blockage of the head arm in the desired
position, slacken the screw ( 1 ) on the lever, hold the bush
( 2 ) in position, turn the lever to the left and tighten the screw.
.
- ATTENTION: In case of electrical drop-out or overload cut-
out, press switch ( 3 ) to start the machine again.
6
1