beautypg.com

Trad 260 - mul – Dake Model TRAD 260 User Manual

Page 11

background image

11

TRAD 260 - MUL

TRAD 260 - MUL

TRAD 260 - MUL

TRAD 260 - MUL

TRAD 260 - MULTI MODE

TI MODE

TI MODE

TI MODE

TI MODE

7.5 - Cutting angle adjustment

- Unlock lever (8) and rotate the saw frame arm until you reach

mechanical stop and check if the index corresponds to 45°; if
not operate on the set screws to make measures meet.

2

3

5

4

7.3 - Vice

- The device does not require any particular adjustment; in case

of excess play of the sliding guide, tighten slide screw more.

7.6 - Saw frame lowering control device

It is an optional accessory, ideal for the cutting of thin or STAIN-
LESS STEEL section bars, that determines a constant lowering
and consequently a good efficiency of the blade throughout the
work phase. This device can be accommodated to the different
situations and applications. Defectiveness in the control of the
lowering may be caused by the drop in braking power of the
device due to the long-term blow-by of the braking fluid.
Push rod (2) back into its seat and loosen plug (3). Use recom-
mended oil to top up oil tank (4) with the help of a syringe-type
pump. Bleed air, after having tightened plug ( 3 ) and loosen
screw (5) lightly until a little oil drip out; when this has been
completed, secure the screw.
Use SHELL HYDRAULIC OIL 32 or similar.

8

A

7.4 - Spring adjustment

The sawframe balance can be adjusted through the handwheel
( A ):

- Put the spring under tension when you operate the machine
manually so that the sawframe can easily raise up to the start
position.
- Reduce the spring tension before you switch to the self -
downfeed function so that the sawframe can descend according
to the downfeed speed adjusted on the regulator ( 5 ).