High Country Tek DVC750 - Manual (Page 7)

DVC750 Product Manual
High Country Tek, Inc.
208 Gold Flat Court
Nevada City, CA, 95959.
Tel:- (1) 530 265 3236
www.hctcontrols.com 021-00196_Rev_A-DVC750_User_Guide 7/9
C. PWM Output Driver Status (3ea 5mm Red/Green)
1
These LEDs indicate how hard the module is driving the corresponding
channel by displaying the duty-cycle status of the output. The LED will
display from red to green as the output duty-cycle changes from 0% to
100% (50% displaying yellow).
D. Module Status (MS) (1ea 5mm Red/Green)
1 Off – There is no power applied to the Module.
2 On green – The module is operating in a normal condition.
3 Flashing green – Device in standby state. May need commissioning.
4 Flashing red – Recoverable Fault.
5 On red – Module has an unrecoverable fault.
6 Flashing Red/Green – Device is in self-test.
E. Network Status (NS) (1ea 5mm Red/Green)
1 Off - Device in not on-line.
2 Flashing green – Device in on-line but has not established connection to
other nodes.
3 On green – Device in on-line and has established connection to other
nodes.
4 Flashing red – One or more connections are in a timed-out state.
5 On red – The device has detected an error that has rendered it incapable
of communicating on the network.
PACKAGING
A. Physical Size: 6.2L” x 4.75W” x 1.65H” encapsulated module.
B. Each module has two mounting holes 4.0” a part. Each mounting hole has an I.D.
of 0.325”.
C. Weight – 1 lb. 7 oz.
CONNECTORS
A. The DVC722 uses a Cinch 1.5 mm SHS series (or compatible) sealed electronic
header designed for severe under-hood environments. IP69K
B. Then CAN Bus connector on the DVC722 is a standard 5-pin M12 type CAN Bus
(DeviceNet compliant) connector.
MATING CONNECTORS
A. DVC Series 48-pin Connector Kit: HCT P/N: 999-10077
Includes the following: