High Country Tek DVC750 - Manual (Page 3)

DVC750 Product Manual
High Country Tek, Inc.
208 Gold Flat Court
Nevada City, CA, 95959.
Tel:- (1) 530 265 3236
www.hctcontrols.com 021-00196_Rev_A-DVC750_User_Guide 3/9
C. Voltage Calibration – Setting for the actual voltage received at the input (Min,
Center and Max).
D. Voltage Limits – sets the Min a Max limits of the input. A flag is set when these
limits are met. This feature detects unwanted conditions so that the controller can
be safely programmed to a default condition
Note – The input will go high if the input is open (no connection).
E.
Invert Output – Simply inverts the output control with respect to the input
command.
F. Enable Ramps – applies ramping to the input.
G. Scaling – sets the offset and gain to the input which results to meaningful data
displayed in the Loader Monitor.
ANALOG INPUTS – Qty (4)
The Analog inputs have a range of 0 to +5Vdc. A +5Vdc Reference is supplied with
each input for an external sensor.
JOYSTICK/VOLTAGE CONFIGURATION OPTIONS
A. Enable Center - sets up upper and lower configuration for single axis joystick.
B. Deadband – Sets the % of deadband at center.
C. Voltage Calibration – Setting for the actual voltage received at the input (Min,
Center and Max).
D. Voltage Limits – sets the Min a Max limits of the input. A flag is set when these
limits are met. This feature detects unwanted conditions so that the controller can
be safely programmed to a default condition
Note – The input will go high if the input is open (no connection).
E.
Invert Output – Simply inverts the output control with respect to the input
command.
F. Enable Ramps – applies ramping to the input.
G. Scaling – sets the offset and gain to the input which results to meaningful data
displayed in the Loader Monitor.
DIGITAL INPUTS – QTY (8)
INPUTS 1 – 8 (SINKING)
A. These inputs are sinking (need +5Vdc to +32Vdc to cause the input to switch
change states).