High Country Tek DVC722 - Manual (Page 3)

DVC722 Product Manual
High Country Tek, Inc.
208 Gold Flat Court
Nevada City, CA, 95959.
Tel:- (1) 530 265 3236
www.hctcontrols.com 021-00194_Rev_A-DVC722_User_Guide 3/7
DIGITAL INPUTS – QTY (40)
1.
These inputs are sinking (need +5Vdc to +32Vdc to cause the input to switch
change states).
2. Indicators – The corresponding green LED will illuminate when the input is
activated (programmable active high or low).
PROGRAMMABLE FEATURES
A.
Inputs
1. Debounce - 0 to 2.5 seconds.
2. Active High or Active Low.
3. Toggle (latching) or No Toggle (non-latching) mode.
B. DVC722 programmable features are set by using the Intella Programming Tool
and then loaded into the DVC710 Master Module.
C. The MAC ID and Baud Rate settings are set at each DVC722 module through
the RS-232 serial port using the Program Loader Monitor. The default value for
MAC ID is 22 and baud rate is 125k unless otherwise noted.
INPUT PROTECTION
A.
Protected against shorts to ground and voltages up to +32Vdc.
+PWR
SINKING INPUT
TO DVC722
CONFIGURATION