Avocent Access Router Cyclades-PR2000 - Manual (Page 74)

Cyclades-PR2000
Chapter 9 - Routing Protocols 74
Area Menu (continued)
Area Range N Status An Area Border Router (ABR) advertises link states for all networks within the area.
The number of such advertisements can potentially be reduced by condensing
different IP networks into a single range.
Area Range N Net
Address Applies when Area Range N Status is Active.
Sets the network IP address for the range.
Area Range N Mask Applies when Area Range N Status is Active.
Sets the network IP mask for the range.
STEP FIVE
The CONFIG =>IP =>OSPF =>NEIGHBORS menu is required if the router uses OSPF over non-broadcast multi-
access interfaces such as X.25 and Frame Relay. If this is the case, set the parameters described in the following
table.
Neighbors Menu CONFIG=>IP =>OSPF =>NEIGHBORS
Parameter Description
Interface Link for which neighbors will be defined. In the OSPF example, consider link 1 of
Router 3.
Neighbor's IP The router ID of the neighboring router. For Router 3, link 1, use the router ID of router
1.
Neighbor's Status Enable includes link in OSPF database.
Enable Inactive leaves link in OSPF database, but router at end of link (Router 1 in this
case) no longer passes OSPF information.
Disable deactivates neighbor link and erases Neighbor’s IP.
Neighbor's Priority Priority used by OSPF in multicast networks to elect the designated router. A priority of
1 will make this router the most likely to be chosen. A priority of 2 will make it second
most likely. Set it to 0 (zero) if this router should never be the designated router. An
example can be seen in Area 1 in the figure -- Router 1 should never be the
Designated Router because it does not have a direct link to Router 2. Either Router 0
or Router 3 should be chosen.