Avocent Access Router Cyclades-PR2000 - Manual (Page 21)

Cyclades-PR2000
21 Chapter 4 - Step-by-Step Instructions
STEP TWO
No more parameters are necessary for the Ethernet interface. The other interface to be configured is the
SWAN. The SWAN physical media parameters are shown in Figure 4.3. Fill in the values for your application.
The SWAN configuration is described in more detail in chapter 6 of the Installation Manual.
Menu CONFIG=>INTERFACE=>SWAN=>PHYSICAL
Parameter
Example Your Application
Mode Asynchronous
Speed 38.4k
FIGURE 4.3 SWAN PHYSICAL MENU PARAMETERS
STEP THREE
The network protocol parameters, shown in Figure 4.4, are similar to those for the Ethernet interface. Fill in the
parameters for your network in the right-most column.