ARI Armaturen CONA all-in-one PN40 EN - Manual (Page 3)

Rev. 0040808000 0808 Page 3
Operating and installation instructions
CONA
®
All-in-one
4.0 Description
4.1 Scope of applications
CONA All-in-one steam traps are used for "condensate-discharge from all kinds of steam
systems".
The information complies to the Pressure Equipment Directive 97/23/EC.
It is the responsibility of the machine planner to ensure compliance.
The special markings on the valve must be taken into account.
Refer to the catalogue sheet to see which materials are used in standard versions.
Please contact the supplier or the manufacturer if you have any questions.
ATTENTION !
- Refer to the data sheet for applications, limits on use and possibilities.
- Certain media require or preclude the use of special materials.
- The valves are designed for standard operating conditions. If conditions exceed
these requirements, e.g. aggressive or abrasive media, the operator should
state the higher requirements when ordering.
- Valves made from grey cast iron are not authorised for use in systems subject
to TRD 110.