Akiles ProLam Photo - Manual (Page 6)

4) Au tomatic memory funct ion
After pressing the control button, within 3 seconds, the machine can automatically save the setting data
(speed, temperature, running mode), these data can be recovered for next operation.
Note: Do not switch off the machine within 3 seconds after pressing the control button, in case the
setting data might damaged.
RE V
1. Digital displ ay and Functions
1) Sleep ing function
A) When the machine does not laminate the document for about 15
minutes continuously, the machine will enter into sleeping function
automatically.
B) Waking up the sleeping function
I) Press any key
II) Restart the power supply
Note: I) W hile entering into sleeping function, the machine cut
o ff heating power supply automatically.
II) Temp display shows SLP and flash .
III) After the roller Temp decrease below 60
, the motor
w ill be turned off automatically.
℃
3) Over-heat protecting fu nction
When the roller Temp over 160 , the o ver-heat protecting circuit will cut off the heating power
supply automatically.
℃
5 6
2. Button function of control panel
1)Temperature contro l
A)These can be used for increasing or decreasing Temp manually. The
Temp can be increased or decreased by unit to 1 when these keys
are pressed. Pressing the key, the Temp will be increased or decreased
continuously until you loose the key.
B)The range of Temp that can be adjusted manually is 0 --160 .
C)When the Temp over 160 , the over-heat protecting system will run
automatically.
D)When pressing the Temp adj. key, it indicates the setting Temp. When
loosing the key for 3 seconds, it indicates the present Temp
automatically.
E)When the Temp reach the setting Temp, the Temp ready lamp lights.
℃
℃ ℃
℃
UP DOWN
TEMP. ADJ. KEY
2) Speed contro l
A)These can be used for increasing or decreasing speed manually. The
speed can be increased or decreased by unit to 1 speed when these
keys are pressed.
B)The range of speed that can be adjusted manually is speed 1to speed 9.
C)Wait for heating
a) If the setting Temp is less than 90 ,when the actual Temp of the
roller increase to 30 below the setting Temp, the motor start.
For example, if the setting Temp is 85 when the actual Temp
of the roller increase to less than 55 the motor will not run.
Once the actual Temp reach to 56 the motor start.
b) If the setting Temp is more than 90 when the actual Temp of
the roller increase to 60 the motor start.
This will protect the machine.
℃
℃
℃ ，
℃ ，
℃ ，
℃ ，
℃，
UP DOWN
SPEED ADJ. KEY
SPEED 1: SLOW
SPEED 9: FAST
3) REV co ntrol Button
Use for r everse operation in em ergency.
Use for r emove articles that ins erted by mistake.
SLP
2) Protecting functio n of Temp sensor's open circuit and short circu it
When the sensor is in short circuit, shows CLS
When the sensor is in open circuit, shows OPN
OPN
CLS
PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.cn