Akiles ProLam Photo User Manual
Page 5
POWER SWIT CH FUSE
WIRE SOCKET
WIRE PLUG
7
1. C ONNEC TIN G THE P OW ER S OURCE
1) Chec king the rate d voltage o n the machi ne, to insure it conform to the powe rsource.Als o,checking
the p lug to insure it conform to the socke t.
2) If the electric wi re does not connect wit h the machi ne, connect it with the w ire socket on the back
of ma chine.
3) Inser t the plug in to the powe r socket tha t is groundin g correct.
4) Turn on the powe r switch, th e display lig ht, it indica tes the pow er is connec ted.
2. HOT LAMINATING
1) Prepa ration
Turn on the pow er switch, the display turns light. Set the Tem p to more t han 60
, the machine
begin to heat. W hen the Tem p increase to the setting Temp, th e constant Temp lamp turns light.
Wait ing for another 2 minu tes, the Tem p get stabl e, then you can begin laminating. During the
work ing period, the Temp c onstant lam p will be light , it indicates that the machine is ready to
laminate.
2) Hot l aminating
Put th e paper into the pouch film, and m ake the seal ed end of po uch in fron t, then inser t it into the
mach ine. (Show n as FIGUR E 1). If put other sides in front, it will bring fold or the machine is
block ed. If the p aper is bloc ked, press the Reverse button, the motor will reverse, and the paper
will withdraw. W hen insert ing the pou ch film int o the mach ine, insure it is betwe en the two
conv ex lines on the input board. Now, the whole laminating operation is finished , a perfect
lamin ated card ap pear on the output boar d.
℃
4
FIGURE 1
POUCH FILM
DOCUMENT
℃
INPUT BOARD
REV BUTTON
SPE ED ADJ . KEY
TEMP. ADJ . KEY
COVER
OUTPUT BOARD
FAN
SPEED DISPLAY
TEMP. DISPL AY
READY LIGHT
SPEED SET
TEMP. SET
SPEED DISPLAY
TEMP. DISPLAY
Rev. Button
SPEED ADJ. KEY
TEMP. ADJ. KEY
READY LIGHT
RE V
RE ADY
PDF 文件使用 "pdfFactory Pro" 试用版本创建