State Tilt Roof - Manual (Page 5)

5
SOLAR COLLECTOR FRAME
MOUNTING CLIP
STAINLESS STEEL BOLT,
LOCK WASHER,
& FLAT WASHER
CHANNEL NUT with SPRING
(One Piece Part)
COLLECTOR
MOUNTING
BRACKET
STRUT
$77$&+,1* &2//(&725 72 02817,1* 67587
Once all of the mounting brackets have been secured to the roof the solar collector(s) can be installed. See Figure 10
for these instructions.
1. Insert the stainless steel channel nut w/spring inside of the collector mounting strut.
2. )DVWHQ WKH VRODU FROOHFWRU PRXQWLQJ FOLS WR WKH FKDQQHO QXW ZLWK WKH VWDLQOHVV VWHHO EROW ORFNZDVKHU DQG ÀDW ZDVKHU
as shown. Do not tighten. Repeat step for the other mounting bracket locations.
3. The solar collector can now be set on the Collector Mounting Struts. To aid in handling the collectors on the roof
the mounting clips may be tightened to the lower end of the Collector Mounting Struts prior to raising the collectors.
The collector can then be set on the lower mounting clips while the top clips are fastened over the lip of the collector
frame.
4. After the solar collector is in position, locate the upper mounting clip so that its lip over-hangs the lip of the solar
collector frame as shown. Tighten the mounting clip to the solar collector frame securely. Repeat for the other upper
mounting clips.
5. Once the upper mounting clips are secured, the lower mounting clips can be loosened and retightened over the
collector lip as directed in step 4
6. Repeat steps as needed for mounting other solar collectors.
Figure 10.