State P6 40 20T4 W - Manual (Page 11)

Temperature Regulation (cont’d)
11
2. Take “OFF” the access panel and fold away the insula-
tion.
3. Turn the water temperature dial(s) clockwise ( ) to
increase the temperature, or counter clockwise ( ) to
decrease the temperature.
4. Fold the insulation back in place and replace the access
panel(s).
5. Turn “ON” the power supply.
Temperature Settings
HOT–Is a thermostat setting of approximately 120°F,
which will supply hot water at the most eco-
nomical temperatures.
A–Is a thermostat setting of approximately
130°F.
B–Is a thermostat setting of approximately
140°F.
C–Is a thermostat setting of approximately 150°F.
VERY HOT–Is a thermostat setting of approximately 160°F.
It is recommended that the dial be set lower
whenever possible.
NOTE: Water temperature range of 120˚-140˚ recom-
mended by most dishwasher manufacturers.
Thermostat Adjustment
On dual element models, both the upper and lower ther-
mostats have been factory set at HOT (approximately
120°F) to reduce the risk of scald injury.
The upper and lower thermostats are adjustable if a differ-
ent water temperature is desired. Read all warnings in the
“Temperature-Regulation” section before proceeding.
To adjust the temperature setting for both upper and lower
thermostats:
NOTE: It is not necessary to adjust the upper thermostat.
However, if it is adjusted above the factory set point
(120°F/HOT) it is recommended that it not be set higher
than the lower thermostat setting.
1. Turn “OFF” the electrical power to the water heater at
the junction box.
Thermostats
UPPER THERMOSTAT
(DUAL ELEMENT MODELS ONLY)
The lower thermostat is factory set at a position which
approximates 120°F (HOT) and is adjustable if a different
water temperature is desired. Read all warnings in this
manual and on the water heater before proceeding.
ADJUSTABLE LOWER
THERMOSTAT
(For dual element models)
ADJUSTABLE LOWER
THERMOSTAT
WITH HIGH LIMIT
The thermostat(s) of this water heater have been factory set
at a position which approximates 120°F (HOT) to reduce
the risk of scald injury.
The upper thermostat is factory set at a position which
approximates 120˚F(HOT) and is adjustable if a different
water temperature is desired. Read all warnings in this
manual and on the water heater before proceeding.
WARNING
HAZARD OF ELECTRICAL SHOCK! Before removing
any access panels or servicing the water heater, make
sure the electrical supply to the water heater is turned
“off”. Failure to do this could result in DEATH, SERIOUS
BODILY INJURY, OR PROPERTY DAMAGE.