Anywhere light manual pg 2 – Maxsa Innovations Anywhere Light User Manual

Page 2

1. In order to mount the light securely to a wall or other stable

surfaces, the mounting base needs to be installed. Slide the

the mounting place to separate it from the main body.

2. If you are installing the mounting place on a very hard

surface, you may need to drill holes for the screws first.

The included screw anchors can be used for drywall,

cement, brick, or similar surfaces.

3. Use the two screws supplied to install the mounting plate.

1. Align the base to the mounting plate. Slide the main body

onto the mounting plate until it snaps into place.

At night, the LED lights will remain on for approximately 40

seconds after the last detected movement. If a movement is

detected while the lights are on, the light duration will be reset

and remain on for another 40 seconds.

Depending on your preferences, you can rotate the base on

the mounting plate or make the motion sensor and the light

swivel to aim at different directions.

because

25 feet

fresh

Anywhere