Maxsa Innovations Solar-Powered Flood Light - Manual (Page 3)

3
MOUNTING TO A FLAGPOLE
To mount on a flagpole, position the flagpole mounting bracket
supplied against the flagpole and run the two supplied metal
bands through the bracket as shown.
*CAUTION: Do not tighten the metal bands until your Solar
Flood Light is where you want it as they cannot be re-opened*
Put the bracket up to the pole and close the metal bands
around the pole, making sure the bands are pulled tight so the
light is firmly secured.
TO MOUNT THE SOLAR PANEL TO A WALL OR ROOF
The solar panel can be mounted to a wall or roof, set on the ground, or attached directly to the
light.
1. Use the two wood/sheet metal screws supplied to mount the solar panel onto a solid
surface. You can adjust the angle of the solar panel by gently rotating it to a different
locking position. Remember to mount the panel facing South, which will maximize the
direct sunlight exposure.
TO MOUNT THE SOLAR PANEL TO THE LIGHT
You will find two bolts protruding from the body of the light. Line up these bolts with the two
mounting holes on the bottom side of the trapezoid that makes up the mounting base of the solar
panel. Push the solar panel base onto these bolts until it is against the surface of the light. Use
the included lock-washers and nuts to tighten the solar panel in place