Pure Evoke-2XT - User Guide - Manual (Page 15)

12
Setting an alarm
EVOKE-2 XT has a daily alarm which switches the radio on (if in standby mode) and tunes to the
station you have chosen or sounds a tone. To set or change an alarm:
1. Press the Menu button to see the current alarm settings.
2. Push the Tune knob if you want to change the alarm settings.
3. Turn the Tune knob to scroll through the following settings and push to change them. The
current setting is shown on the top line of the screen.
Set alarm Set the alarm on or off.
Set time Turn the Tune knob to set the hours, push the Tune knob, turn again and push to
set the minutes.
Set mode Choose between a DAB radio alarm (set to latest station tuned to in that mode)
or Tone alarm. The alarm volume will be whatever the volume control is set at
when the alarm goes off.
When finished, press the menu button or wait to exit. You will see a bell symbol on the screen
next to the clock showing that an alarm is set. Note If you set a DAB alarm and the station is
not available when it is due to go off, a tone alarm will sound instead.
When the alarm goes off, EVOKE-2 XT will beep or tune to the station you have chosen. You see the
clock and the backlight flashing on screen. You cancel the alarm as follows:
Radio alarm Press any button to cancel the alarm and perform the button’s normal function.
Tone alarm Push the Tune knob or Standby to cancel the alarm.
All alarms will automatically stop after 60 minutes if not cancelled and your EVOKE-2 XT will go into
standby.
stress-free mix
Classic FM
Alarm - set icon
Alarm - settings