Pure Chronos iDock - Manual (Page 13)

11
Other options
Display
Press the Menu button and select ‘Display’. You can customise the display settings for both
Active and Standby modes. The diagram below shows the available options.
Active mode: Backlight settings that apply when the unit is switched on.
Standby mode: Backlight settings that apply when the unit is in Standby.
Timed: The display backlight brightens when a button is pressed then
switches off after no button has been pressed for a few seconds.
Always on: The display is constantly on as defined by your Brightness and
Contrast settings.
Auto dimming: The display backlight alters automatically depending on the ambient
light conditions.
Brightness: Adjust between 1 (very dim) and 9 (very bright).
Contrast: Adjust between 1 (low) and 16 (high).
Setting the clock
Clock set
You can manually set the time and date if required. If you have a DAB signal the time and date
will be updated automatically.
12/24 Hour set
Choose 12 hour or 24 hour clock display
Display
Brightness Contrast
Timed Always on
Active mode Standby mode
< 1 - 9 > < 1 - 16 >
Timed Always on Auto dimming