Outback Power Systems FLEXware 250 - Users Guide - Manual (Page 6)

Welcome to OutBack Power Systems’ FLEXware 50
FLEXware is a convenient all-aluminum power system offering simple, code-compliant
installation of OutBack power electronics components. Three versions of FLEXware are
available:
• FLEXware 250 for single FX Series Inverter/Charger installations along with the desired AC
and DC disconnects
• FLEXware 500, which supports up to two FXs and two OutBack Series Charge Controllers,
accommodating both split-phase and/or higher power output as needed
• FLEXware 1000 accommodates up to four FXs and four OutBack Series Charge Controllers
Note: Both the FLEXware 500 and the FLEXware 1000 power systems provide locations for
FW-X240 Auto-Transformers, multiple DC shunts and other essential components required in
higher kW systems.
FLEXware 50 Parts List
The FLEXware 250 consists of an aluminum enclosure which can be used for either the AC or
DC side of an FX Series Inverter/Charger. Each FLEXware 250 includes:
• Installed ground bus bar
• Breaker Guard (for DC installations)
• Hardware Kits for mounting to an FX and for securing AC and DC breakers (refer to the
hardware bag label for a complete listing of parts)
• Cover Plate
• Breaker Label Kit
The chassis itself features conduit knockouts (see Figures 2-5) and knockouts for AC breakers
and DC breakers.
• DC installations include a slot for either a 175 or 250 amp OBDC breaker and slots for four
load breakers.
• AC installations allow for the optional 120/230 VAC Input/Output/Bypass Assembly
(IOB) kit.
Optional Parts:
• FW-IOB (Input/Output/Bypass Assembly) Kit for 120/230 VAC.