Dee Zee DZ43301 - Manual (Page 2)

FOR INSTALLATION ON DRIVER'S SIDE ONLY
STEP 4) STEP 6) STEP 8)
Use a T45 torx socket or the Install the cable back onto Remove the other end of the
wrench provided to remove the the cable bolt, and the tailgate cable with the T45 torx
cable bolt. Remove the tailgate larger part of the shock and remove the motion limiter.
cable from the bolt. on the ball mount.
The flat retaining nut must be
taken off to remove the limiter.
To remove the limiter, pry up one edge of the
flat nut with a screwdriver. Hold this edge with a
pair of pliers and spin the bolt out of it.
STEP 5)
Install the bolt removed from STEP 7) Once the limiter is removed, reinstall the cable
the previous step through the Install the narrow end of the mount to the tailgate.
hole in the ball mount plate back shock on the ball mount
into the hole. previously installed. STEP 9)
on the ball mount. Measure down from the top of the cable 3 1/2". This is where the cable
clip needs to start. Press the clip onto the cable with a pair of pliers.
Failure to remove the limiter and to install the cable clip will cause the
Tighten the bolt with the T45. cable to bind or become caught between the shock and truck bed.
This may lead to vehicle damage, so these steps MUST be done.
DZ 43301 9/25/2013